![]() I have tried different J ports on the multiplexer and checked the wires and see no crimps or cuts. Immediately, as I pull out the pump Green/Yellow connector, Screenlogic immediately responds to commands. Again, pump has good comm and Screenlogic nothing. ![]() I also have the multiplexer as well (520789), so I hooked the pump up to one of the Green/Yellow connectors and Screenlogic Antenna to one of the Green/Yellow/Black/Red connectors and connected the multiplexer to J20. ![]() I am using the intellibrite on/off command (Aux 1 and Aux 2) to troubleshoot responsiveness between Screenlogic app and the ET board. When I remove the Green/Yellow wires for the pump, the pump, of course, goes into NO COMM under status, but Screenlogic commands are received from the app without delay. Whenever the Green/Yellow comm cables from the Intelliflo VS are plugged into J20 at the same time as the Green/Yellow comm cables (plus Black/Red) from the Screenlogic antenna, Screenlogic will not respond to commands, but pump shows good connection to the system. I have the pool and spa and spillway working just fine, but a problem has arisen. I have recently taken my system back to the beginning and erased the EEPROM and started reconnecting everything from scratch. I have the ET8 system (pool/spa combo) with the Intelliflo VS and Screenlogic2. I have been reviewing the forum and cannot find a solution to my problem in other threads.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |